Functions specific to SCALANCE
3.4 SRS
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
97
This section describes commands for the Siemens Remote Service (SRS).
To use the platform, additional service contracts are necessary and certain constraints must
be kept to. If you are interested in SRS, call your local Siemens contact or visit
http://support.automation.siemens.com/WW/view/en/42346681
(http://support.automation.siemens.com/WW/view/en/42346681).
Note
This command is only av
ailable with a KEY-PLUG.
This command shows the configured destination server of the Siemens Remote Service
(SRS).
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Call the command without parameters:
show srs overview
The configuration is displayed.
To Next Page
Loading...
Need help?
General
