Siemens SCALANCE S615 - No Ip Routing

Network protocols
6.1 IPv4 protocol
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
181
Result
The routing function is enabled.
Further notes
You disable the function with the no ip routing command.
You display the setting with the
show ip route command.
6.1.2.8
no ip routing
Description
With this command, you disable IPv4 routing function on the device.
Note
IPv6 routing
If IPv6 routing is enabled on the device, this is also disabled with this function.
Note
This command is available only with layer 3.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip routing
Result
IPv4 routing is disabled.
Further notes
You enable the function with the ip routing command.
You display the setting with the
show ip route command.