Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
320 Configuration Manual, 06/2015, C79000-G8976-C406-02
The interval is configured.
You display this setting and other information with the show firewall information command.
idle timeout tcp
Description
With this command, you configure the required period for TCP. If no data exchange takes
place, the TCP connection is terminated automatically when this time has elapsed.
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Call up the command with the following parameters:
idle timeout tcp <second(1-4294967295)>
The parameter has the following meaning:
The interval is configured.
You display this setting and other information with the show firewall information command.
With this command, you create your own IPv4 rules for the firewall. These IPv4 firewall rules
have a higher priority than the predefined IPv4 firewall rules.
To Next Page
Loading...
