Siemens SCALANCE S615 - Ntp Time Diff

System time
4.2 NTP client
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
129
Syntax
Call up the command with the following parameters:
no ntp server
Result
The connection to a server is deleted on the NTP client.
Further notes
You configure the connection to a server with the ntp server command.
4.2.3.3
ntp time diff
Description
With this command, you configure the time difference between the device and the NTP
server.
Requirement
You are in the NTP configuration mode.
The command prompt is as follows:
cli(config-ntp)#
Syntax
Call up the command with the following parameters:
ntp time diff <(+/-hh:mm)>
The parameter has the following meaning:
Parameter
Description
+
Time zones to the west of the NTP server time zone
-
Time zones to the east of the NTP server time zone
hh
Number of hours difference
mm
Number of minutes difference
Enter the number of hours and number of minutes with two digits each.
Default: No time difference.
Result
The time difference between the device and the NTP server is configured.