Siemens SCALANCE S615 - No Interface

Configuration
2.1 System
SCALANCE S615 Command Line Interface
54 Configuration Manual, 06/2015, C79000-G8976-C406-02
Result
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
The placeholder
$$$ is replaced by the following name of the interface:
Type of interface
Command prompt
vlan
cli(config-if-vlan-$)#
fastethernet
cli(config-if-F-X)#
The placeholders $ and X stand for the numbering of the interface.
The ranges of values from the physical interfaces depend on the hardware configuration.
Further notes
You exit the Interface configuration mode with the end or exit command.
You delete a logical interface with the
no interface command.
You display the status and the configuration of the interfaces with the
show interfaces
command.
2.1.9.5
no interface
Description
With this command, you delete a logical interface.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no interface{vlan<vlan-id(1-4094)>}
The parameters have the following meaning:
Parameter
Description
Values
vlan
Keyword for a VLAN connection
-
vlan-id
Number of the addressed VLAN
1 … 4094