Siemens SCALANCE S615 - Snmp; The Show Commands; Show Snmp

Network protocols
6.6 SNMP
SCALANCE S615 Command Line Interface
222 Configuration Manual, 06/2015, C79000-G8976-C406-02
6.6
SNMP
This section describes commands of the Simple Network Management Protocol (SNMP).
6.6.1
The "show" commands
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
Example
do show cli-console-timeout
6.6.1.1
show snmp
Description
This command shows the status information of SNMP.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show snmp
Result
The status information is displayed.