Siemens SCALANCE S615 - Wbm; Show Web-Session-Timeout; Commands in the Global Configuration Mode

Functions specific to SCALANCE
3.2 WBM
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
91
3.2
WBM
On the device, you can limit the time available for access with Web Based Management. If
no entry is made for a specific time, the WBM session is closed.
This section describes commands relevant for the configuration of this feature.
3.2.1
show web-session-timeout
Description
This command shows the timeout setting for the WBM.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show web-session-timeout
Result
The timeout setting for the WBM is displayed.
3.2.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.