Siemens SCALANCE S615 - Permitted ambient conditions; Design, dimensions and weight; Installation options; Mounting position

Configuration
2.1 System
SCALANCE S615 Command Line Interface
64 Configuration Manual, 06/2015, C79000-G8976-C406-02
2.1.10.7
negotiation
Description
With this command, you enable autonegotiation of connection parameters on an interface.
Autonegotiation must be set for every interface of connected interfaces.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
negotiation
Result
The automatic negotiation of connection parameters on an interface is activated.
Further notes
You disable the autonegotiation of connection parameters with the no negotiation
command.
2.1.10.8
no negotiation
Description
With this command, you disable autonegotiation of connection parameters on an interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no negotiation