Siemens SCALANCE S615 - Certificates; Commands in the Global Configuration Mode; Certificate

Security and authentication
9.4 Certificates
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
407
9.4
Certificates
This section describes commands relevant for certificates.
9.4.1
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
9.4.1.1
certificate
Description
With this command, you change to the CERT configuration mode.
Requirement
You are now in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
certification
Result
You are now in the CERT configuration mode.
The command prompt is as follows:
cli(config-cert)#
Further notes
You exit the CERT configuration mode with the end command.