Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
337
Enables the predefined firewall rule.
Disables the predefined firewall rule. -
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL configuration mode".
The predefined firewall rule HTTP is enabled on the relevant interface. The WBM can be
accessed using HTTP.
You display this setting and other information with the show firewall pre-rules ipv4
command.
You list the available interfaces with the
prerule ipv4 show-int command.
Commands in the FIREWALL configuration mode (Page 313)
prerule https ipv4
Description
With this command, you enable the predefined firewall rule for HTTPS on the selected
interface.
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Call up the command with the following parameters:
prerule http ipv4 {int <interface-type> <num(0-10)> | all-int} {enabled|disabled}
The parameters have the following meaning:
Keyword for the interface
Type or speed of the interface Specify a valid interface.
To Next Page
Loading...
Need help?
General
