Siemens SCALANCE S615 - Ddnsclient; Commands in the DNS CLIENT Configuration Mode

Network protocols
6.5 DNS
SCALANCE S615 Command Line Interface
210 Configuration Manual, 06/2015, C79000-G8976-C406-02
6.5.2.4
ddnsclient
Description
With this command, you change to the DDNS Client configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
ddnsclient
Result
You are now in the DDNS Client configuration mode.
The command prompt is as follows:
cli(config-ddnsclient)#
Further notes
You exit the DDNS Client configuration mode with the end or exit command.
6.5.3
Commands in the DNS CLIENT configuration mode
This section describes commands that you can call up in the DNS CLIENT configuration
mode.
In the Global configuration mode, enter the
dnsclient command to change to this mode.
● If you exit the DNS CLIENT configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the DNS CLIENT configuration mode with the
end command, you return to the
Privileged EXEC mode.