Siemens SCALANCE S615 - UK Declaration of Conformity; The Equipment and Protective Systems Intended for use in Potentially Explosive Atmospheres Regulations 2016

Configuration
2.2 Load and Save
SCALANCE S615 Command Line Interface
74 Configuration Manual, 06/2015, C79000-G8976-C406-02
The command prompt is as follows:
cli(config-loadsave)#
Syntax
Call up the command with the following parameters:
delete{showfiles|filetype<filetype>}
The parameters have the following meaning:
Parameter
Description
Range of values / note
showfiles
Shows the available files
-
filetype
Keyword for the file type to be deleted -
filetype
Name of the file type
max. 100 characters
Result
The files are displayed or the file is deleted.
Further notes
With the "show loadsave files" command, you can display the file types.
2.2.5.2
tftp filename
Description
With this command, you assign a name to a file type.
The file type decides the type that is affected by the
tftp load or tftp save action. The
name decides the file to be copied to or from the TFTP server.
Requirement
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Syntax
Call up the command with the following parameters:
tftp filename {showfiles|filetype< filetype >name<filename>}