Siemens SCALANCE S615 - Nat-Keep-Alive

Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
362 Configuration Manual, 06/2015, C79000-G8976-C406-02
The parameters have the following meaning:
Parameter
Description
Range of values / note
yes
CRL is used
-
no CRL is not used -
ifuri
Is only used when a CRLURL is de-
fined.
-
Result
The setting is configured.
Further notes
You display this setting and other information with the show ipsecvpn information command.
9.3.3.5
nat-keep-alive
Description
With this command, you specify the interval at which sign of life frames (keepalives) are
sent.
Requirement
You are in the IPSEC configuration mode.
The command prompt is as follows:
cli(config-ipsec)#
Syntax
Call up the command with the following parameters:
nat-keep-alive <sec(1-10000)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
sec
Interval Enter the required interval.
1 ... 10000 sec
Result
The interval is configured.