Siemens SCALANCE S615 - Prerule Ip Ipv4

Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
338 Configuration Manual, 06/2015, C79000-G8976-C406-02
Parameter
Description
Range of values / note
num
Interface index Specify a valid interface
index.
0 ... 10
all-int
Enables the predefined firewall rule on all inter-
faces.
-
enabled
Enables the predefined firewall rule.
-
disabled
Disables the predefined firewall rule. -
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL configuration mode".
Result
The predefined firewall rule HTTPS is enabled on the relevant interface. The WBM can be
accessed using HTTPS.
Further notes
You display this setting and other information with the show firewall pre-rules ipv4
command.
You list the available interfaces with the
prerule ipv4 show-int command.
See also
Commands in the FIREWALL configuration mode (Page 313)
9.2.4.27
prerule ip ipv4
Description
With this command, you enable the predefined firewall rule for IPv4 services on the selected
interface.
Requirement
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
prerule ip ipv4 {int <interface-type> <num(0-10)> | all-int} {enabled|disabled}