Network structures
5.1 VLAN
SCALANCE S615 Command Line Interface
148 Configuration Manual, 06/2015, C79000-G8976-C406-02
With this command, you assign a protocol to a protocol group.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
map protocol
{ip | novell | netbios | appletalk | other <aa:aa>}
enet-v2 protocols-group <Group id integer(1-100)>
The parameters have the following meaning:
Appletalk
Other protocol. enter the hexadecimal protocol
value.
• other: aa:aa
• IPV6:
86:DD
• LLDP:
88:CC
• PTP IEEE1588:
88:F7
• EAP (802.1X):
Frame structure is Ethernet II
Keyword for a protocol group
The protocol group is created.
You delete the protocol group with the no map protocol command.
You can display the status of this function and other information with the
show vlan
protocols-group
command.
To Next Page
Loading...
Need help?
General
