Siemens SCALANCE S615 Configuration Manual

Network structures
5.1 VLAN
SCALANCE S615 Command Line Interface
162 Configuration Manual, 06/2015, C79000-G8976-C406-02
5.1.3.8
no switchport pvid
Description
With this command, you reset the setting for the port VLAN identifier (PVID) for an interface
to the default value.
The default value is 1.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport pvid
Result
The setting is reset to the default value.
Further notes
You configure the setting with the switchport pvid command.
You configure the VLAN ID with the
switchport access vlan command.
You can display the status of this function and other information with the
show vlan port
config
command.
5.1.4
Commands in the VLAN configuration mode
This section describes commands that you can call up in the VLAN Configuration mode.
In the Global Configuration mode, enter the
vlan $$$ command to change to this mode.
When doing this, you need to replace the
$$$ placeholders with the relevant VLAN ID.
Commands relating to other topics that can be called in the VLAN Configuration mode can
be found in the relevant sections.
● If you exit the VLAN Configuration mode with the
exit command, you return to the Global
Configuration mode.
● If you exit the VLAN Configuration mode with the
end command, you return to the
Privileged EXEC mode.

Siemens SCALANCE S615 Specifications

General

Protocols	IPsec, OpenVPN
Power Supply	24 V DC
Mounting Type	DIN Rail
Product Name	SCALANCE S615
Ports	5
Firewall	Yes
Weight	0.6 kg
Certifications	CE