Siemens SCALANCE S615 - No Snmp Group

Network protocols
6.6 SNMP
SCALANCE S615 Command Line Interface
238 Configuration Manual, 06/2015, C79000-G8976-C406-02
Parameter
Description
Range of values / note
security-model
specifies which security settings will be
used
•
v1
•
v2c
•
v3
Storage type specifies whether the settings remain
following a restart
•
volatile (volatile):
The settings are lost after a
restart
•
nonvolatile (non-volatile):
The settings are retained after
a restart
If optional parameters are not specified when configuring a group, the default values apply.
Result
The details of the group are configured.
Further notes
You delete the details of an SNMP group with the no snmp group command.
You display the created SNMP groups with the
show snmp group command.
You display the created SNMP user with the
show snmp user command.
6.6.2.11
no snmp group
Description
With this command, you delete the details of an SNMP group.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no snmp group <GroupName> user <UserName>security-model{v1|v2c|v3}