Diagnostics
10.1 Event and fault handling
SCALANCE S615 Command Line Interface
432 Configuration Manual, 06/2015, C79000-G8976-C406-02
With this command, you disable the setting for the threshold values for the sending of
system event notifications.
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli (config-events) #
Call up the command with the following parameters:
no severity { mail | log | syslog }
The parameters have the following meaning:
The setting of the threshold value for
sending system event messages by e-
-
The setting of the threshold value for
entering system event messages in the
-
The setting of the threshold value the
entering event messages in the Syslog
-
If you do not select any parameters from the parameter list, the default value is used.
The settings for sending system event messages are configured.
You enable the setting with the severity command.
You display the status of this function and other information
show events severity.