Network structures
5.1 VLAN
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
147
no interface range
Description
With this command, you remove the interfaces or interfaces of VLANs from the interface
range or break it up if you first remove all previously added interfaces.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
no interface range vlan <vlan-id(1-4094)> - <vlan-id(2-4094)>
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN
Number of the addressed VLAN
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you address several VLANs, you must insert a blank before and after the hyphen, for
example
no interface range vlan 5 - 10.
The VLANs have been removed from the specified interface area.
With the interface range command, you can put several interfaces or VLANs together to be
able to configure them together.
To Next Page
Loading...
Need help?
General
