Siemens SCALANCE S615 - Proxy Server; Show Proxyserver Table; Commands in the Global Configuration Mode

Network protocols
6.9 Proxy server
SCALANCE S615 Command Line Interface
256 Configuration Manual, 06/2015, C79000-G8976-C406-02
6.9
Proxy server
This section describes commands for the proxy server.
6.9.1
show proxyserver table
Description
This command shows the configuration of the proxy server.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call the command without parameters:
show proxyserver table
Result
The configuration is displayed.
6.9.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
6.9.2.1
proxyserver
Description
With this command, you change to the PROXYSERVER configuration mode.