Siemens SCALANCE S615 - Conn-Mode; Subnet

Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
369
You configure the remote subnet with the subnet command.
You display this setting and other information with the
show ipsec remoteend command.
9.3.4.3
conn-mode
Description
With this command, you specify the role the remote stations will adopt.
Requirement
You are in the IPSEC REMOTE END configuration mode.
The command prompt is as follows:
cli(config-ipsec-rmend-X)#
Syntax
Call up the command with the following parameters:
conn-mode <roadwarrior|standard>
The parameters have the following meaning:
Parameter
Description
Range of values / note
roadwarrior
Roadwarrior mode
The device accepts VPN connections from remote sta-
tions with an unknown address.
-
standard
Standard mode
The device establishes a connection to or from a known
remote station. The remote station is identified by the IPv4
address or the DDNS hostname.
-
Result
The role is configured.
Further notes
You display this setting and other information with the show ipsec remoteend command.
9.3.4.4
subnet
Description
With this command, you configure the remote subnet of the VPN remote station.