Siemens SCALANCE S615 - Show Sntp Status; Show Sntp Unicast-Mode Status

System time
4.3 SNTP client
SCALANCE S615 Command Line Interface
132 Configuration Manual, 06/2015, C79000-G8976-C406-02
4.3.3
show sntp status
Description
This command shows the settings of the Simple Network Time Protocol.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show sntp status
Result
The settings of SNTP are displayed.
4.3.4
show sntp unicast-mode status
Description
This command shows the current configuration of the unicast mode of SNTP.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show sntp unicast-mode status
Result
The current SNTP unicast configuration is displayed.