Network protocols
6.1 IPv4 protocol
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
179
The parameter has the following meaning:
Specifies the IP address or the address
range
specify a valid IP address
Specifies the subnet mask used for
prefix.
enter a valid subnet mask
Specifies the IP address to which the
selected addresses will be forwarded.
specify a valid IP address
The value for the administrative dis-
1 ... 255
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The entry in the IP routing table is configured.
You delete an entry from the IP routing table with the no ip route command.
You display the IP routing table with the
show ip route command.
With this command, you delete a static entry from the IP routing table.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
no ip route <prefix> <mask> <next-hop> [<distance(1-255)>]
To Next Page
Loading...
Need help?
General
