Load control
7.2 Dynamic MAC aging
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
283
mac-address-table aging-time
Description
With this command, you configure the aging of a dynamically learned entry in the MAC
address list.
Note
Addresses with light data traffic
For addresses with low data traffic, it is recommended to enter a higher value for the aging.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
mac-address-table aging-time <seconds(10-1000000)>
The parameter has the following meaning:
Life of the entry in seconds
At system start or when using the restart command with the option memoryor factory, the
following defaults apply:
● The default value is 300 seconds.
The value of the aging of a dynamically learned entry is configured.
You can reset the setting to the default with the no mac-address-table aging-time command.
You display the setting with the
show mac-address-table aging-time command.
To Next Page
Loading...
Need help?
General
