Network protocols
6.10 SMTP client
SCALANCE S615 Command Line Interface
268 Configuration Manual, 06/2015, C79000-G8976-C406-02
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
● If you exit the EVENTS configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the EVENTS configuration mode with the
end command, you return to the
Privileged EXEC mode.
sender mail-address
Description
With this command, you configure the e-mail name of the sender.
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Call up the command with the following parameters:
sender mail-address <mail-address>
The parameter has the following meaning:
The e-mail name of the sender is configured.
You reset the e-mail name of the sender with the no sender mail-address.
You display the setting with the
show events sender email command.
no sender mail-address
Description
With this command, you reset the e-mail name of the sender.
To Next Page
Loading...
Need help?
General
