Siemens SCALANCE S615 - SMTP Client; Show Commands; Show Events Smtp-Server; Show Events Sender Email

Network protocols
6.10 SMTP client
SCALANCE S615 Command Line Interface
266 Configuration Manual, 06/2015, C79000-G8976-C406-02
6.10
SMTP client
This section describes commands of the Simple Mail Transfer Protocol (SMTP).
6.10.1
show commands
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
Example
do show cli-console-timeout
6.10.1.1
show events smtp-server
Description
This command shows the configured SMTP servers.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show events smtp-server
Result
The configured SMTP servers are displayed.
6.10.1.2
show events sender email
Description
This command shows the configured e-mail sender address.