Siemens SCALANCE S615 - Logon IDX Pw

Functions specific to SCALANCE
3.4 SRS
SCALANCE S615 Command Line Interface
106 Configuration Manual, 06/2015, C79000-G8976-C406-02
3.4.3.8
logon idx pw
Note
This command is only avai
lable with a KEY-PLUG.
Description
With this command, you change the password for access to a specific destination server.
Requirement
You are in the SRS configuration mode.
The command prompt is as follows:
cli(config-srs)#
Syntax
Call up the command with the following parameters:
logon idx <num(1-100)> pw <string(100)>
The parameters have the following meaning:
Parameter
Description
Range of values / note
num
Number corresponding to a specific
destination server.
Enter the required number.
pw
Keyword for the password
-
string
Password Specify the user name.
Maximum of 100 characters
Result
The password for the access is changed.
Further notes
You change the user name with the logon idx name command.
You display the numbers of the destination servers with the
logon show-idx command.