Configuration
2.4 Configuration Save & Restore
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
85
The CLI can save changes to the configuration automatically.
If you first want to test changes made to the configuration so that you can discard them
afterwards if necessary, you can disable the auto save function.
You are then in the Trial mode.
Changes to the configuration that you have not saved, are indicated by an asterisk in front of
the command prompt:
*cli(...)#.
You save the changes to the configuration with the
write startup-config command.
With the
auto-save command, you enable the auto save function.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
auto-save
As default the function is "enabled".
The auto save function is enabled.
You save changes to the configuration in the Trial mode with the write startup-config
command.
You disable the function with the
no auto-save command.
You can display the status of this function and other information with the
show device
information
command.
To Next Page
Loading...
Need help?
General
