Functions specific to SCALANCE
3.5 SINEMA RC
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
109
Introduction to the SRC section
This section describes commands for access to the SINEMA RC Server. You will find further
information on this in the Operating Instructions of the SINEMA RC Server.
Note
This command is only available with a KEY
-PLUG.
This command shows information on SINEMA RC.
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Call the command without parameters:
show sinemarc
The information is displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.