Network structures
5.1 VLAN
SCALANCE S615 Command Line Interface
154 Configuration Manual, 06/2015, C79000-G8976-C406-02
With this command, you delete a VLAN on the device.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameter:
no vlan <vlan-id(2-4094)>
Number of the addressed VLAN
The VLAN with number 1 cannot be deleted.
The VLAN is deleted
With the vlan command, you create a VLAN on the device.
You can display information about the VLAN with the
show vlan command.
Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
To Next Page
Loading...
Need help?
General
