Siemens SCALANCE S615 - Clear Fault Counter

Diagnostics
10.1 Event and fault handling
SCALANCE S615 Command Line Interface
418 Configuration Manual, 06/2015, C79000-G8976-C406-02
10.1.2
clear fault counter
Description
With this command you reset the counter that shows the number of faults since the last
startup.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call the command without parameters:
clear fault counter
Result
The counter is set to "0".
Further notes
You shows the number of faults since the last startup with the show fault counter command.