Siemens SCALANCE S615 - No Service

Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
349
Parameter
Description
Range of values / note
range
Keyword for a port range
-
number
Start port 0 ... 65535
Specify the start port and end port, e.g.
10 - 20
number
End port
Result
The service is configured.
Further notes
You delete this service with the no service command.
You display the service with the
show firewall ip-services command.
9.2.4.38
no service
Description
With this command, you delete all services or a specific service.
Requirement
● The corresponding service has been created and is not being used anywhere.
● You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
no service {name <string(32)> | all}
The parameters have the following meaning:
Parameter
Description
Range of values / note
name
Keyword for service name -
string
Service name Specify a valid service name.
Maximum of 32 characters
all
Deletes all service names
-