Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
317
The parameters have the following meaning:
ICMP service name Specify a valid service name.
Maximum of 255 characters
Keyword for the ICMP packet type -
Number corresponding to a specific
ICMP packet type.
Enter the required number.
Keyword for the code of the ICMP
-
Number corresponding to a specific
code.
Enter the required number.
The selection depends on the ICMP
The ICMP packet type and code have been changed.
You display the available service names with the icmp show-names command.
You show the available ICMP packet types and codes with the
icmp show-types-codes
command.
You delete this service with the
no icmp command.
You display this setting and other information with the
show firewall icmp-services ipv4
command.
icmp show-names
Description
With this command, you display the available ICMP service names.
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Call the command without parameter assignment:
icmp show-names
To Next Page
Loading...
Need help?
General
