Siemens SCALANCE S615 - Show Vlan Protocols-Group; Commands in the Global Configuration Mode

Network structures
5.1 VLAN
SCALANCE S615 Command Line Interface
144 Configuration Manual, 06/2015, C79000-G8976-C406-02
5.1.1.6
show vlan protocols-group
Description
This command displays the table with the protocol group entries.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show vlan protocols-group
Result
The table of protocol groups is displayed.
5.1.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.