Siemens SCALANCE S615 Configuration Manual

Network protocols
6.2 ARP
SCALANCE S615 Command Line Interface
186 Configuration Manual, 06/2015, C79000-G8976-C406-02
6.2
ARP
This section describes commands of the Address Resolution Protocol (ARP).
6.2.1
show ip arp
Description
With this command, you display the IP ARP table.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show ip arp [{Vlan<vlan-id(1-4094)>|<interface-type><interface-id>|
<ip-address>|<mac-address>|summary|information}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
Vlan
Keyword for a VLAN connection
-
vlan-id
Number of the addressed VLAN 1 ... 4094
interface-type
Type or speed of the interface
Enter a valid interface.
interface-id
Module no. and port no. of the interface
ip-address
Shows the IP addresses of the entries
in the ARP table
-
mac-address
Shows the MAC addresses of the en-
tries in the ARP table
-
summary
Shows a summary of the entries in the
ARP table
-
information
Displays information on the ARP con-
figuration
-
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you do not select any parameter from the parameter list, the IP ARP table is displayed.
Result
The IP ARP table is displayed.

Siemens SCALANCE S615 Specifications

General

Protocols	IPsec, OpenVPN
Power Supply	24 V DC
Mounting Type	DIN Rail
Product Name	SCALANCE S615
Ports	5
Firewall	Yes
Weight	0.6 kg
Certifications	CE