Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
327
ipv4rule set log
Description
With this command, you change the making of entries in the firewall log.
● The IPv4 firewall rule has been created.
● You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Call up the command with the following parameters:
ipv4rule idx <number(1-100)> set log {no|info|war|cri}
The parameters have the following meaning:
Number corresponding to a spe-
cific IPv4 rule.
Enter the required number.
1 ... 100
Keyword for making entries in the
-
The rule coming into effect is not
-
Messages about event severity
"information" are logged.
-
Messages about event severity
-
Messages about event severity
-
Entering in the firewall log has been changed.
You display this setting and other information with the show firewall ip-rules ipv4
command.
You obtain the numbers with the
ipv4rule show-rules command.