Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
324 Configuration Manual, 06/2015, C79000-G8976-C406-02
ipv4rule set action
Description
With this command, you change the action taken with incoming IPv4 packets.
● The IPv4 firewall rule has been created.
● You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Call up the command with the following parameters:
ipv4rule idx <number(1-100)> set action {drop|acc|rej}
The parameters have the following meaning:
Number corresponding to a spe-
cific IPv4 rule.
Enter the required number.
1 ... 100
Keyword for the action with in-
-
The data packets can pass
-
The data packets are discarded
without any notification to the
-
The data packets are rejected,
and the sender receives a corre-
-
The action taken with the corresponding IPv4 firewall rule has been changed.
You display this setting and other information with the show firewall ip-rules ipv4
command.
You obtain the numbers with the
ipv4rule show-rules command.
To Next Page
Loading...
Need help?
General
