Siemens SCALANCE S615 - No Src-Nat

Layer 3 functions
8.1 NAT
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
299
Parameter
Description
Range of values / note
dstip
Keyword for the destination IP address.
-
ip_addr
IPv4 address Enter a valid IPv4 address.
ip_range
IPv4 address range Specify a valid IPv4 address
range.
subnet
IPv4 address for the subnet Specify the subnet in CIDR
notation.
transip
Keyword for the IPv4 address with which the
IPv4 address of the source is replaced.
-
ip_addr
If the interface has an IPv4 address, the pa-
rameter is optional. In this case, the IPv4 ad-
dress of the interface is used.
Enter a valid IPv4 address.
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL NAT configuration mode (Page 288)".
Result
The source NAT rule is created. During creation, an entry with a unique number (index) is
created.
Further notes
You delete a source NAT rule with the no src-nat command.
You delete all source NAT rules with the
no src-nat all command.
You display the numbers of the source NAT rules with the
src-nat show-idx command.
You display the source NAT rule with the
show firewallnat src-nat command.
8.1.3.12
no src-nat
Description
With this command, you delete a specific source NAT rule.
Requirement
You are in the FIREWALL NAT configuration mode.
The command prompt is as follows:
cli(config-fwnat)#