Siemens SCALANCE S615 Configuration Manual

Network protocols
6.10 SMTP client
SCALANCE S615 Command Line Interface
270 Configuration Manual, 06/2015, C79000-G8976-C406-02
Parameter
Description
Note on the range if values
FQDN(100)
Domain name (Fully Qualified Domain
Name)
Maximum of 100 characters
receiver mail-
address
Name of the recipient max. 100 characters
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 25)".
Result
An entry for the SMTP server is configured.
Further notes
You delete an SMTP server entry with the no smtp-server command.
6.10.2.4
no smtp-server
Description
With this command, you delete an SMTP server entry.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
no smtp-server {ipv4 <ucast_addr> | fqdn-name <FQDN(100)>}
The parameters have the following meaning:
Parameter
Description
Range of values/note
ipv4
Keyword for an IP address
-
ucast_addr
Value for an IPv4 unicast address Enter a valid IPv4 unicast ad-
dress.
fqdn-name
Keyword for a domain name
-
FQDN(100)
Domain name (Fully Qualified Domain
Name)
Maximum of 100 characters
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 25)".

Siemens SCALANCE S615 Specifications

General

Protocols	IPsec, OpenVPN
Power Supply	24 V DC
Mounting Type	DIN Rail
Product Name	SCALANCE S615
Ports	5
Firewall	Yes
Weight	0.6 kg
Certifications	CE