Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
363
You display this setting and other information with the show ipsecvpn information command.
remote-end name
Description
With this command, you change to the REMOTE END configuration mode. In this mode, you
configure the other settings.
If the matching VPN remote station does not exist, the VPN remote station is first created.
You are in the IPSEC configuration mode.
The command prompt is as follows:
cli(config-ipsec)#
Call up the command with the following parameters:
remote-end name <name(100)>
The parameter has the following meaning:
Name of the VPN remote station Enter the name for the VPN re-
You are now in the IPSEC REMOTE END configuration mode.
The command prompt is as follows:
cli(config-ipsec-rmend-X)#
X is a placeholder for the name
You exit the IPSEC REMOTE END configuration mode with the end or exit command.
You delete a VPN remote station with the
no remote-end name command.
You delete all VPN remote stations with the
no remote-end all command.
To Next Page
Loading...
Need help?
General
