Siemens SCALANCE S615 - Dcp Server; No Dcp Server

Network protocols
6.1 IPv4 protocol
SCALANCE S615 Command Line Interface
176 Configuration Manual, 06/2015, C79000-G8976-C406-02
6.1.2.1
dcp server
Description
With this command, you configure the read and write permissions for the DCP server and
enable it.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
dcp server {read-only|read-write}
The parameters have the following meaning:
Parameter
Description
Range of values / note
read-only
only reading is permitted on the DCP
server
-
read-write
reading and writing is permitted on the
DPC server
Default: read-write
Result
The read and write permissions for the DPC server are configured.
The DCP server is enabled.
Further notes
You disable the DCP server with the no dcp server command.
6.1.2.2
no dcp server
Description
With this command, you disable the DCP server.
Requirement
You are in the Global configuration mode.