Functions specific to SCALANCE
3.4 SRS
SCALANCE S615 Command Line Interface
102 Configuration Manual, 06/2015, C79000-G8976-C406-02
The destination server entry is created. During creation, an entry with a unique number
(index) is created.
You display this setting and other information with the show srs overview command.
You display the numbers of the destination servers with the
logon show-idx command.
You change the settings with the
logon idx addr, logon idx group, logon idx name and
logon idx pw commands.
You delete the destination server entry with the
no logon command.
is command is only available with a KEY-PLUG.
With this command, you delete a specific destination server or all destination servers.
You are in the SRS configuration mode.
The command prompt is as follows:
cli(config-srs)#
Call up the command with the following parameters:
no logon {idx<num(1-100)> | all}
The parameters have the following meaning:
Keyword for the number of the destina-
-
Number corresponding to a specific
Enter the required number.
Deletes all destination servers
To Next Page
Loading...
Need help?
General
