Diagnostics
10.1 Event and fault handling
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
429
Client that sends the SNMP traps
Error LED lights up. The setting is possible only for a cold or warm restart.
Controls the digital output or signals the status change with the "DO" LED.
Controls the VPN connection (establishment/termination).
The setting deciding which messages of the device are not stored or forwarded is
configured.
You display the status of the events and the clients with the show events config command.
You configure which of the various message types of the device will be stored or forwarded
with the
event config command.
With this command, you configure and enable the monitoring of the physical network
connections for cable breaks or for pulling of the connector.
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli(config-events)#
Call up the command with the following parameters:
link {up|down}
The parameters have the following meaning:
Only the establishment of a connection is signaled
Only a break on a connection is signaled
To Next Page
Loading...
Need help?
General
