Siemens SCALANCE S615 - Service Name Set Src

Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
352 Configuration Manual, 06/2015, C79000-G8976-C406-02
Further notes
You display the available service names with the service show-names command.
You create the service with the
service name command.
You display this setting and other information with the
show firewall ip-services
command.
9.2.4.41
service name set src
Description
With this command, you change the source port.
Requirement
● The service name has been created.
● You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
service name <string(32)> set src {all| port <number(0-65535)>| range <number(0-
65535)> - <number(0-65535)>}
The parameters have the following meaning:
Parameter
Description
Range of values / note
string
Service name Specify a valid service name.
Maximum of 32 characters
all
Applies to all ports. -
Port
Keyword for a port
-
number
Port number 0 ... 65535
Specify the required port.
range
Keyword for a port range
-
number
Start port
0 ... 65535
Specify the start port and end port, e.g.
10 - 20
number
End port
Result
The source port of the corresponding service has been changed.