Siemens SCALANCE S615 - No Name; Ports

Network structures
5.1 VLAN
SCALANCE S615 Command Line Interface
166 Configuration Manual, 06/2015, C79000-G8976-C406-02
5.1.4.4
no name
Description
With this command, you delete the name assignment for a VLAN.
Requirement
You are in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call the command without parameters:
no name
Result
The name of the VLAN is deleted.
Further notes
You assign the VLAN a name with the command name.
5.1.4.5
ports
Description
With this command, you generate a list that specifies the behavior of the interfaces and
replaces the existing VLAN configuration.
● Member ports (tagged ports)
The interface is added permanently to the list of incoming and outgoing connections.
Tagged and untagged frames are transferred.
● Untagged Ports
The interface transfers untagged frames. If the VLAN ID (PVID) is set, incoming
untagged frames are given a tag with the VLAN ID specified there. If the received frames
already contain a VLAN ID, frames are only accepted if their VLAN ID matches the set
PVID. With outgoing frames, the tag with the VLAN ID is removed.
● Forbidden Ports
This interface is not used for communication in a VLAN.
The "tagged port" and "untagged port" you specify with this command are used for outgoing
data traffic.