Siemens SCALANCE S615 - No Dpd

Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
389
Requirement
You are in the IPSEC PHASE configuration mode.
The command prompt is as follows:
cli(config-conn-phs1)#
Syntax
Call the command without parameter assignment:
dpd
Result
DPD is enabled. Using DPD, it is possible to find out whether the VPN connection still exists
or whether it has aborted.
Further notes
You display this setting and other information with the show ipsec conn-phase1 command.
You disable DPD with the
no dpd command.
9.3.7.6
no dpd
Description
With this command, you disable DPD.
Requirement
You are in the IPSEC PHASE configuration mode.
The command prompt is as follows:
cli(config-conn-phs1)#
Syntax
Call the command without parameter assignment:
no dpd
Result
DPD is disabled.