Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
374 Configuration Manual, 06/2015, C79000-G8976-C406-02
The parameters have the following meaning:
Local subnet address Specify the local subnet in CIDR notation.
The local network can be a single PC or another sub-
set of the local network.
DNS host name
For information on identifiers of addresses and interfaces, refer to the section Interface
identifiers and addresses (Page 25).
The local subnet is configured.
You display this setting and other information with the show ipsecvpn connections command.
With this command, you specify the VPN remote station for the IPsec connection.
● The VPN remote station has been created.
● You are in the IPSEC CONNECTION configuration mode.
The command prompt is as follows:
cli(onfig-conn-X)#
Call up the command with the following parameters:
rmend name <name(128)>
The parameter has the following meaning:
Name of the VPN remote station
The VPN remote station has been configured.
To Next Page
Loading...
Need help?
General
