Siemens SCALANCE S615 - Snmp Targetaddr

Network protocols
6.6 SNMP
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
241
The parameter has the following meaning:
Parameter
Description
Range of values / note
NotifyName
Name of the notification
max. 32 characters
Result
The details of the SNMP notifications are deleted.
Further notes
You change the details of an SNMP group with the snmp notify command.
You display the configured SNMP notifications with the
show snmp notif command.
You display the configured SNMP target addresses with the
show snmp targetaddr
command.
6.6.2.14
snmp targetaddr
Description
With this command, you configure the SNMP target addresses.
Requirement
● The SNMP target parameters are configured.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp targetaddr <TargetAddressName> param <ParamName> {ipv4<IPAddress>}
[timeout <Seconds(1-1500)] [retries <RetryCount(1-3)]
[taglist <TagIdentifier | none>] [{volatile | nonvolatile}]
[port <integer (1-65535)>]
The parameters have the following meaning:
Parameter
Description
Range of values
TargetAddressName
Name of the target address max. 32 characters
param
Keyword for the parameter name
-
ParamName
Name of the destination address or
the designation of the parameter
name
max. 32 characters