Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
344 Configuration Manual, 06/2015, C79000-G8976-C406-02
Call up the command with the following parameters:
prerule tftp ipv4 {int <interface-type> <num(0-10)> | all-int} {enabled|disabled}
The parameters have the following meaning:
Keyword for the interface
Type or speed of the interface Specify a valid interface.
Interface index Specify a valid interface
index.
Enables the predefined firewall rule on all inter-
-
Enables the predefined firewall rule.
Disables the predefined firewall rule.
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL configuration mode (Page 313)".
The predefined firewall rule TFTP is enabled on the interface. Communication using TFTP is
allowed.
You display this setting and other information with the show firewall pre-rules ipv4
command.
You list the available interfaces with the
prerule ipv4 show-int command.
prerule ping ipv4
Description
With this command, you enable the predefined firewall rule Ping on the selected interface.
You are in the Firewall configuration mode.
The command prompt is as follows:
cli(config-fw)#
To Next Page
Loading...
Need help?
General
