Configuration
2.2 Load and Save
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
73
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
loadsave
You are now in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
You exit the LOADSAVE configuration mode with the exit command.
Commands in the LOADSAVE configuration mode
This section describes commands that you can call up in the LOADSAVE configuration
mode.
In the Global Configuration mode, enter the
loadsave command to change to this mode.
You display the valid file types for the commands in the LOADSAVE Configuration mode
with the global command
show loadsave tftp.
● If you exit the LOADSAVE configuration mode with the
exitcommand, you return to the
Global Configuration mode.
● If you exit the LOADSAVE configuration mode with the
end command, you return to the
Privileged EXEC mode.
With this command, you call up the possible files or delete a specific file.
You are in the LOADSAVE configuration mode.
To Next Page
Loading...
Need help?
General
